Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by ramiruddin

  1. R

    [SOLVED] PAE Class-E Power Amplifier Problem

    hi @FvM, It's get the higher output power because it use two-stages scheme with the same transistor, isn't it?
  2. R

    [SOLVED] PAE Class-E Power Amplifier Problem

    hi @vfone, I appreciate your reply. I have tried to decrease the power output and gain target to be 28 dBm or 28 dB gain (with 0 dBm power input). when I tried to decrease the power output and gain target to 28 dBm, I can't reach =< -10 dB return loss input and output. the return loss input and...
  3. R

    [SOLVED] PAE Class-E Power Amplifier Problem

    Hi, I Already design Class-E Power Amplifier using MMG15241H (freescale : https://www.nxp.com/products/rf/rf-amplifiers-low-medium-power/wideband-amplifiers/general-purpose-amplifiers/500-2800-mhz-15.9-db-24-dbm-e-phemt:MMG15241H?tab=Design_Tools_Tab) with the linear model transistor (S2P...
  4. R

    S-Parameter can't be changed using S2P format ADS

    When I tried to change component using microstrip line, it can work only at 2,5 Volt dc bias whereas on the datasheet bias value at 5 volt
  5. R

    S-Parameter can't be changed using S2P format ADS

    Hi, I have designed power amplifier using data items model (S2P format) in ADS, but when I tried to change the bias voltage (Vdc), s-parameter simulation results did not change (S11, S22, S21). What's wrong with that??
See more

Part and Inventory Search

Back
Top