Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am a fourth year communication Engineering student.
I am about to start the project on wired sensor network.
Please suggest me, from where should I start my project
and information about the research going on this topics.
Waiting for suggestion and informations
Simulation project are best and may seems to be easy.
But it is really tough when doing.
Physical things are to be realized in the virtual way
In my opinion the best project will be
simulation of the CDMA channel
I AM HAVING PROBLEM WITH MY SONY ERICSSION MOBILE PHONE
IT IS NOT EVEN STARTING WHEN I PRESS POWER BUTTON.
I HAVE FOUND THAT IT HAS a software problem.
PLEaSe any one can supply me the software that can re program the firmware through data cable.
I think you have enabled the security code. I think there is a default security code given in user manual, try it. Else, open the cover of your mobile phone and remove the small battery. after that press power button. again place the battery and start the phone.
I am not quite sure in the case...
I am having problem with K600i model mobile phone.
Suddenly this mobile phone starting hanging during operation.
None of the keys worked after that even power button didn't respond.
so i took the battery out and restarted again. when i started again it worked fine
but again same problem. Then...
I am having problem with connection of main circuit board with LCD.
LCD has no connecting soldered leads, it has just glass.
Previously the connection was made through plastic conductive wire
but accidently it was broken. So please suggest any repairing methods or instrument I should use.
Hi! nice idea. It is possible to control the robot thorugh serial port in MATLAB but I don't know about the Parallel port controlling. There is a good tutorial on serial port communication in matlab version 7. Try it with Serial port.
h bridge bjt
I have designed the Hbridge with the BJT BC108 to drive the motor which draws 400mA current. But it does nothing when I connect the motor in the terminals of H bridge. When I remove the motor and check with LED it worked fine but not when motor is connected.
Datasheet of BC108...
I know that we use modem is used to convert the analog signal over the telephone to computer.
Why can't we use modem as the analog to digital converter in the PC based oscilloscope system.
To begin this type of program what should I do.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
