Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello everyone ,
i have one doubt how to generate two randomsequence like scenarios in AXI protocol
1) data comes first and address for same data after that and
2) the reverse address comes first and data after that .how to use RANDSEQUNCE for this or we can use other thing.
thanks
plot gm vs id
Id/W vs. gm/Id does not depend to first order on Vds
hi Sutapanaki, can u plz tell me this in more detail....
What i have seen is mostly diode connected confuration is used to plot Current density plot.
HOwever for subthreshold region Current Density Plot I had used fixed bias at...
site:www.edaboard.com offset psrr
hello friends
i want to know how to simulate the gm using the calculator in mentor graphics or any link related to this from which i can understand
also tell about the other parameters like cmrr ,psrr and offset
thanks in advance
source degeneration
hi
i want to know the advantages of using the source degeneration in terms of output voltage swing and settling time or any link related to this topic
thanks
capacitive load, ota, resistor
i want to know why OTA are used for driving the capacitive loads is there any problem when they drive the resistive load
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.