Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by Rajeshtr

  1. R

    PORTE problem 16F877A

    It's in the header file
  2. R

    PORTE problem 16F877A

    After commenting the BUZZER _PIN HIGH the led becomes stable.. otherwise toggling
  3. R

    PORTE problem 16F877A

    Yes ma'am..if the BUZZER _PIN is commented there is no issues for the PIN RE2
  4. R

    PORTE problem 16F877A

    RE1 connected to Buzzer pin RE2 connected to an LED
  5. R

    PORTE problem 16F877A

    how to configure PORTE of 16F877A PIC controller..PORTE.RE2 shows toggling issue when RE1 signal occurs in mikro c
  6. R

    Lcd shows wrong misaligned values

    After commenting that particular section the same issue arises
  7. R

    Lcd shows wrong misaligned values

    values are displayed one by one..up to 3 switch cases in settings menu everything is fine.. but goes to the 4th case error occurs
  8. R

    Lcd shows wrong misaligned values

    Hi this is a 6 adc channel reading program and we have to set the reference value using micro switches ..display all the values in lcd...the problem is after entering in to the settings menu lcd values changes misaligned in display..otherwise the program is fine..please help
  9. R

    PIC 16F877A

    It's done .but the same issue arises..Only this port have this complaint
  10. R

    PIC 16F877A

    How can we configur PORTE.2 PIN as output pin..Using Mickro c pro and 16 F877A
  11. R

    Pic 16f877a

    Do u have any program for this?
  12. R

    Pic 16f877a

    This is the concept I want..thanx in advance 😊
  13. R

    Pic 16f877a

    Hi,I want a solution for button program..I have 6 gas and I want to monitor the pressure level..I want to set the reference point,ie low level, normal and high level that needs to be alarmed.. this is using 3 buttons..can anybody help please?....🙄i want to save this eeprom memory..I had...
See more

Part and Inventory Search

Back
Top