Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear all,
Now I found the problem, now it is working as usual, I did in reset pin number 9 of AT89C52 just touch a wire with 5 volt positive 3 - 4 times now it is work as 12hrs format, after (0) 9 : 5 9 it is going to 1 0 : 0 0 and as usual, I mean the 4th digit of 10hrs digit is working, I...
Thanks,
Yes, earlier it was worked correct 12hrs format that is after (0)9 : 5 9 it ran to 1 0 : 0 0 but some unknown reason now it is going after (0)9 : 5 9 to (0) 0 : 0 0, I mean the forth digit of 10hrs digit (showed inside the brackets) that is not light up, only three digits are working.
My name is Rajagopal 70 years old, I knows basic electronics but no experience in current programming.
I have purchased a few 7 segment 4 digit pcbs with AT89C52, RTC DS1307, 74LS595 (4nos), and ULN 2003 (4nos) 12hrs format and program preloaded assembled clock PCBs.
I did 12” ...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.