Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks FvM. Surely I will need to ramp up to 5 KHz. Are you aware of any stepper motor in the size of 42 frame, that can run to this speed?
The load the motor is going to bear will be around 0.4 Kg.
Hi all :)
A very nice and interesting discussion going on here. Quite learning.
I want to drive a stepper motor(1.8 Step Angle)at 1500 RPM, for which I require 5KHz freq. If I supply a clock signal of 5Khz to the Clk pin of l297, will I get the same freq. on output i.e ABCD of motor? I will be...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.