Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
copy file c
Hi,
If i follow ur instruction for copy file in c. but it's work for .txt only but if i copy .doc or .xls etc. file than this file cannot copy properly.
Regards
Re: RMON configure
Yes I use Concord NMS & I capture what is communication between NMS & Agent.
Initailly NMS queary for System MIB , Interface MIB upto this all queary response properly by agent but after that NMS queary for RMON & Agent fail to give the response & my agent cannot detect in...
Re: RMON configure
Thanks cdcll for reply ,
I already implemented System OID, Interface OID but still my device not detected in Concard or HP Open view Server.
Once , again thanks for ur reply,
Regards
Rahul Sanghavi :)
For CAN
https://www.kvaser.com/
https://www.microchip.com
For I2C
https://www.esacademy.com/faq/i2c/
https://www.microchip.com
For SPI
https://www.microchip.com
Regards
Rahul Sanghavi
There are certain reasons for UPS cannot give Output Voltage during Inverter mode:
1) MOSFET cannot fire or work properly
2) Inverter Transformer damage(short or open internally)(if use)
3) Battery supply cannot connect properly with Drain or MOSFET or with Transfomer
Regards
Rahul :?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.