Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
dear emresel,
I have follow your instructions about neural network. By combined the data using prestd and trastd it is a little bit complex. The MSE also different compared to the first solution (using separate data). At now, Im still using the separate data and process it one by one. My target...
dear emresel,
thanks a lot and i have tried it and its work. Now im trying to train with different angle because different angle give different measurement value. Should i separate it to different dataset or combine it together in one dataset? For example, have 90 degrees and 80 degrees of...
Yes emresel. I did like that.
There sensor output and actual value is taken from 0cm until 110cm and have an error between sensor output and actual measurement when the distance increased.
Can i use neural network to get the sum square error(sse) so it can verify the performance of the sensor...
Thanks for reply emresel,
I have converts sensor analog output to distance in cm by using c program and used the value in 'cm' for NN. I have a little bit confused how to compare sensor value and measurement value by using NN. I did like this for NN.
1. Input data set = sensor value
2. Output...
Hello. I have constructed a neural network by using Matlab software. I got a data from 2 sensors which is ultrasonic sensor and distance sensor. These two sensor will give an ouput voltage for distance measurement. So i want to evaluate the sensor performance by using neural network. The...
Hello. Im using PIC16F877. I have tried to program Sharp Distance sensor and try to display the value in USART terminal by using micro C pro. There have 3 pin, RA1, GND and Vin. There have a problem because the value were not display in USART terminal.I have set the serial connection to COM3...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.