Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Whats wrong with my full wave bridge rectifier
Thank you for the reply. i tried impedance matching using smith chart utility. If L1 is dropping most of the voltage, should i avoid using inductor in matching. What are the ways i should try to increase efficiency?
- - - Updated - - -
Thank...
Re: Whats wrong with my full wave bridge rectifier
Thank you for the reply.
I tried impedance matching using smith chart utility. If L1 is dropping most of the voltage, should i avoid using inductor in matching. What are the ways i should try to increase efficiency?
Re: Whats wrong with my full wave bridge rectifier
Thank you for the reply. I am getting output of the rectifier by vout2-vout1 as shown in the equation. The thing is i am getting very low efficiency. Even impedance matching is not helping me to get higher efficiency.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.