Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Attached buck design works fine with UC3845B operating at Freq of100KHz and Input voltage of 56V. Since my input varies from 36 to 56V, UC3843A may have to be used... With UC3843A plugged in, I don't see any output at all. At pin 6, a 96% Duty cycle square waveform appears. Should it not be...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
