Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I got it charging briefly in fast charge but it seems to fault out after a moment of fast charge.
I believe its going to fault state because the Von - Voff > Vctst (page 12 on datasheet) . Anyone know if you can set the resistor smaller than specified 20k ohm from CTST pin to gnd?
Yea, its a switched mode charger with fast charge of 1 amp (precharge and maintenance charge at 250mA).
The transistors I'm using are straight from the specified part in the schematic in the datasheet and aren't getting exceedingly hot anymore.
I fixed some wiring issues so it matches the...
I'm trying to setup the DS2712 in 2-cell series switched with the attached schematic. I'm double checking wiring at the moment , but wanted to verify the schematic was correct.
My Q2 bjt is getting extremely hot and all my current is running back through the inductor and d1 in a loop.
Any help...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
