Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for your reply biff44. So I should use resistors in small packages.
But how will the resistor affect the impedance of the line?
---------- Post added at 02:33 ---------- Previous post was at 02:23 ----------
Thanks RCinFLA. I am aware of the small inductance that any via and 0 Ohm...
Hello everyone.
I would like to ask for comments regarding my problem.
I am currently designing a GSM system that requires me to use 50-ohm coplanar waveguide on one system and 50-ohm microstrip on another. Along these impedance controlled lines, I have impedance matching networks. We are still...
I have been using OrCAD 16.0 for a while now and have gotten used to it. Recently, I installed OrCAD 16.2 to my machine. And as soon as I opened the Pad Designer to make a new padstack, I noticed little differences between the two versions. The selection for Type (Through, Blind/Buried, Single)...
cadence spb
I have attached an image to explain what I meant. The black line is the pad, while the red line is the solder resist. As you can see, the resist is 6 mils bigger on all sides compared to the pads. I drew the pad already, is there a way to automatically make it 6 mils bigger on all...
cadence allegro
Thank you for your reply.
I have another question though, is there a way to automatically generate a solder resist for the irregularly shaped pad that I made? Its a bit time consuming having to draw another shape. Or is there a way to expand all the edges at the same time?
allegro spb
Hi to all, I am a new user of Cadence Allegro SPB 16.0 but I have been doing PCB layouts for quite a while already using another software(Zuken CR-5000). I would like to know how i can go about making irregularly shaped pad stacks in Allegro. And if there is anyone that can give me...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.