Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear Sam,
Thanks for your reply. I have seen many papers citing LEDA and SAED libraries. I have SAED 90nm but could find any link about LEDA 90nm.
Thanks anyways,
BR,
Qazi
Hi,
I have a design of a circuit that is synthezied using "lec25dscc25_TT" library. I want to resuse the design to synthesize it using Design Compiler, but I do not have this specific library. "lec25dscc25_TT". Could someone help, if I could get this library? Or is there any other way to...
Hello,
Thanks, this commabd worked out by given certain net number. but I need number of components in different levels. could not find any command about level and components information in it.
Hi,
I want to obtain the number of components before a specific net and its level. I am using Design complier and trying to used "report_transitive_fanin" command. But it show -TO missing.
Could some one please help.
Thanks,
Regards,
Q
I already have got power report using X-Power Analyzer, I can see it hierachically. Component means, "FF", LUTs, Registers etc. How can I save them separately. And importantly, how this can be feasible and practical if the chip is fabricated. In simulation I can generate a power report, but how...
I am interested to get the dynamic power consumption of each of the component of a micro-controller. Can I do it by adding the power lines in place and route (PAR)? The purpose of it to get the more precised power consumption of a MC. In simulation I can do it by several means, but what would be...
Hi,
I am trying to analyze dynamic power of different components of a Circuit. The power of some components is too low that it does not show in mW. I assume if I could be able to show in MicroWatts, it would be possible to analyze those also. Is there any way to get the power report in...
Hi,
I have the following UCF file for Spartan-6 FPGA. Currently I am using Virtex-5 XC5VLX20T ff323 to implement my design. How can I convert the same file according to Virtex 5. If someone has already, please share.
Regards,
Qazi
How to Run C application on MC 8051 design using Xilinix isim.
Hi, I want to run some C applications on my MC 8051 Design. It would take a binary file of a C application as an input, right? How can I get this binary?
Regards, Qazi
But I have done several times and several with versions of vcd of different designs. What could be the problem with my VCD? After implementing, I have ran simulations for certain time (30ms) and obtained the vcd. I have attached one of the vcd file. If you could look at it?
Qazi ..
Hi,
I am using Xilinx ISE (13.61) to implement my design into FPGA. I want to analyze the dynamic power of my circuit, preferably, component wise. I have uploaded my (.ncd, .pcf and .vcd) files in Xilinx Xpower analyzer, but I am facing the following error.
"ERROR:Power:1976 - $scope with no...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.