Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am new to LDO (Low Voltage Regulator) world.
I'm curious what you people had buy and have in your personal stock at home.
(also what packages, TO-220 SOT-223)
From the good old Ebay I spot a couple and also open their respective dataSheets:
I have 1 circuit composed from 3 little very simple circuits I want to power them all from a 5V@1A power source.
All of these 3 circuits must be powered at different voltages.
Their current draw I measured for each of them.
A=4V @10mA, B=3.4V @1.6mA, C= 5V @24mA
What can you suggest?
Thank you.
i need to turn on/off a led (just to see how usb port work)-and if a script in c++/pascal/VC++;#) is available i dont mind.
you can make a script to ON/OFF a led to a USB port?
can anyone know any usb software for I/O transmit data?
not script but already made software.
i need to command from usb a servo motor(futaba).
or on/off a led (just to see how this usb port work)-and if a script in c++/pascal/VC++;#) is available i dont mind.
thanks.
servo motor controller board futaba
my bad after all. i manage ,huh, to make light in this case.
my bloody f.. son of transistor b...ach com1 was burned already.
i tested at another computer and it worked at 2400 baud rate only ; why 2400?
and i put pololu mode in VSA.
thanks for your...
servo max232
you can give me some details about your wirings?
or software you use? or settings in windows you made?
please i am at the limit.
thank you.
servo+motor+futaba
i play with VSA and i managed to send data to LPT (parallel port) on custom at desire pins and fv.
the software is good , no doubt.
i have already , from my previews experiments, pluged in some LED-s on each pin send data parallel port (from 1-9=8pins to send information)...
futaba s3003 motor
a image worth 1000 words.
here is with no max232.
only the yellow led stay on (no blink). -- it means that controller have power. And thats it.
this is the setup i made for my Controller.
and..
this is the setup i made for VSA
servo motor futaba
hi. i need assistance for making to run an servo motor (futaba S3003)
i also buy,for this motor a Micro Serial Servo Motor Controller from "pololu "
see here the controller itself : **broken link removed**
i buy also an CI MAX 232 for redistributing the voltage (from port...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
