Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
debug unreachable points in lec tool
Hello,
The points whcih are unreachable are shown Unreachable and Not -NOT mapped.
Not Mapped points defination says , the point is reachable but do not have cooresponding point in the other design.
I have Already explained the scenario.
Thank You...
lec equivalent check unreachable
Hi,
Thank You,
I will confirm on this...
But the Point is the RTL means Golden is not changed then how the Point is Becoming Not Mapped?
For Not-Mapped Unmapped Points it has to be reachbale ....right?
Wheather that point is in Reference Design or not should...
conformal unreach
RTL to Netlist,
Thank You,
Sachin Shashikantrao Pampattiwar
Added after 3 minutes:
by the way ...
for your information...
In the same Setup where I am getting the point Not Mapped...
I have done few exercise..I have set the root module for which I was getting the Point...
sachin shashikantrao pampattiwar
Thank You For the Reply,
I am debugging Un-Mapped Points because,
Whenever I debug the Not Equivalent Point, I come across the Non-Mapped Point as a Non Corresponding Support.
So I am assuming that this is the cause of the failure.
Thank You,
Sachin...
lec unreachable
Here is the Scenario of the Problem I am facing.
1.Read a Golden Design and a Revised Design
Map the Points and Compare
2.Read the Same Golden Design and The Different Revised Design.
This time the Revised Design has been created by changing some Constarints in DC
The...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
