Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi johnsomw,
The internet is a very rich source of information. you can try going to
microwaves101.com
or check out the book Microwave Engineering by Pozar.
Hope this helps, goodluck!
Hi khirat,
microstrip patch antennas are passive devices, no voltage, current, or any signal can vary its behavior, and so when designed and printed on a board, gives only a specific response. You need to vary the physical dimensions of the layout to obtain a different response, this means that...
Enjunear already answered your question. the problem is the TEE which you placed between the MCURVE's.
Another alternative is to draw your ratrace on an EM Planar simulator.
Since you already have the dimensions required from your calculations. Just make two circles, one with a radius equal to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.