Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Does any budy know how tuning is done in IE3D, means if i want to see a micro strip feeding result at width 1.5-3 with step 0.1. can IE3D calculate such type of simulation in a single run.. or at each time we have to change strip width manually.
Hello friends...
I am working on micro strip patch antenna but m getting problem in coaxial feed... i don't know what's diameter of cable should be used. Is it different for different patch or there is some standered dia of coaxial? If it is standered then plz tell me what is it...and how...
hello, thank you.....pls can you explain it in more detail by some steps or by any example of that, so i can a better understand of that.. i m new for ie3d and my area of research is fully dependent on this software.
Hi,
Plz help me if anyone of you know this...I am getting difficulty in IE3D software, actually i want to tilt or incline Ground plan at some angle. Is it possible in this software... Plz help me to know this.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
