Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hey man, I've been using a DTMF decoder CM8870, I've opened the PCB mike box, and have connected the right,left and ground wires to a male jack and then connected to a female jack and again to a male jack pin..the pin had sleeve,tip and ring..nd to sleeve, right to tip and left to ring. If...
Okay I've downloaded a CCS C compiler, do I need to download a C30 compiler? It's a PIC mid range MCU PIC16f877 that I'm using..
---------- Post added at 16:15 ---------- Previous post was at 16:13 ----------
I've written the program in MPLABX the free version, I have MIKRO PRO C too...
Hey when I'm using PIC16f877, I don't have to explicitly mention the TXEN ,the baud and stuff right? I mean I can simply use -> #use rs232(baud=9600,xmin=c.6,rcv=c.7,parity=N,stream=rs232,bits=8)
Am I write?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.