Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello everyone,
i Have designed a patch antenna and i am also getting good low return loss below -10dB.. I want to know how to measure impedance bandwidth?
I have IE3D 14 version on my PC...Please give your valuable suggestions..
Thank You..!!
Guys pls help if any1 had encountered similar problem.. I have finished designing the slotted patch now i dont know how to model capacitor in ie3d and put into the slots of the patch..
Re: help needed in ie3d
hey, can u pls tel me how to design capacitance or diode in ie3d....my project is vey much similar to urs....i am designing dual band microstrip antenna with 4 slots and capacitors in the slots...Till now i hav not been able to design capacitors in ie3d..Pls help!!
Guys pls reply, if anybody has encountered a similar problem...I still don knw hw 2 design the capacitor and because of which my project cant mov ahead!!
hello, is it possible to model capacitors of particular value say 1 pF in ie3d....i am stuck because of the same..i m trying to design a dual band microstrip antenna and i want to tune the 2 freq by putting capacitor at edge..Pls help!!
I am designing a dual band microstrip antenna having low frequency ratio(around 1.25-1.4).For that i require to add capacitors into the slots in my patch..By varying the capacitance , I have to check the change in the two frequencies..Please help me regarding-
1.How i can add capacitor on my...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.