Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Keith,
Thank you very much. There was problem with syntax error however the model file also had to be modified as follows;
1) changed length and width to l and w respectively.
2) LTSpice is not recognizing v(n2,n1) from the model file. had to remove the voltage coefficient equations from
r1...
Hi,
I'm using LTSpice to run my spice simulations. Following is the .subckt definition for nwell resistor in 0.18u tech model file.
.lib RES
.subckt rnwod n1 n2 l=length w=width
.param rsh=440 dw=0.141u ptc1=3.68e-3 ptc2=9.54e-6 pvc1=2.77e-3 pvc2=2.49e-4 pt='temper'
.param...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
