Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thanks for the help appreciate it but the microcontroler is not operating any high voltage devices the problem is they are near by the microcontroller as and when these are switched on the microcontroller starts misbehaving i tried taking out the load cell signals but still it starts to...
the problem is not the software everything works fine i think the issue is interference can you tell me some methods to reduce interference due to emi
thanks
Hi
Currently I am working on a weight based system using atmega32. everything works fine until a high powered motor or pump is switched on, the controller starts to misbehave i.e. it starts taking input on its own and works erratically.
I thought the problem is with supply so i separated...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
