Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by poornanop

  1. P

    802.22 standard for spectrum sensing

    I could not find it . Is there a link for downloading it?
  2. P

    802.22 standard for spectrum sensing

    Hi All, I wanna design a distributed amplifier for spectrum sensing section of cognitive radios based on IEEE 802.22 standard. I googled about IEEE 802.22 but I couldn't find something to work. I need design specification for such an amplifier, for example: Bandwidth,Gain,Noise Factor and ...
  3. P

    I've designed a Distributed Amplifier in ADS

    I used DC Block with Term1 and Term4 As you said but this makes no difference in S31 result. Besides, When I run a DC simulation , nodes have voltage
  4. P

    I've designed a Distributed Amplifier in ADS

    Hi All, I've got really confused with this... I've designed a distributed amplifier with following data using N-MOS (L=0.18um and W=10um) : fc = 12 GHz , Z0= 50 Then simulate the circuit in ADS , It's cut-off frequency works properly but It's Gain is 0 until 12 GHz! I've attached two pictures ...
See more

Part and Inventory Search

Back
Top