Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
PROBLEM: B+ and other secondary voltages tends to go down after a few seconds.standby voltage of 5 volt is present. all components on the primary and secondary are ok.
maybe anyone could help why it would go to stndby.
tv-21st2
sorry for the late reply, thanks guys i appeciate your help..
i found out that the B+ diode was leaky(RU2), I tested it out of circuit.
Now the tv is working fine..:D
mc83a chasis, powers on then revert to stnby aftr 2-3 secs.
i've checked b+ (115v)and its ok .stnDby voltage is 5v..
what could be causing this problem, any help would be appreciated.
str-s6307
TV is dead at first, i've found out that B+ diode(UF5405) is short.i've also check for other short near the HOT section.after replacing the shorted diode i tested the unit but it only lasted for 5mins then the unit is dead again.now, str s6307 is shorted and fuse blackened.also B+...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.