Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
can you help me i am wiring up the tc35i to start i have connected the 5 BAT+ & 5 GND.
What do i do about the IGT?
there is no switch i dont require one, and i am not connected it to any other equipment, i just want to dial it and it turns automatically.
please help.
Ally
Hello,
I have few sim900 SMT Surface mount technology.
I need to program these quickly i was wondering if there is any sockets that i can purchase that would facilitate this?
The sim900_TE_v1.03_pcb has a module soldered on to it, i was wondering if i can somehow replace this with a type of...
Hello,
tried
at+cusd=1\r" //
error
Anyway that infernal continous ringing has stopped. Probably sorted out the other bugs too!
2.45 am going to bed
Thanks
Ally
Hello got the solution!!!
switch power off until it ask you to switch on the flash untility. Have patients wait a while!
It works any probs ask me!
Ally
Hello Fellow Dudes,
Recently i have connected a TC35i via Development board, everything is okay.
Doing the dialing thing and messging thing!
I am totally new to this & i have bothered to read both the AT Commands sheet for the TC35I.
Mr & Mrs dudes,
I want the gsm module to become voice or...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
