Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am new to Altium. So might be very noob questions but I could not figure out what's the problem. I tried to use the auto stiching function and found out it could not stiching areas where has other polygons carry different signal.
So I deleted all the auto stiching vias and redo them manually...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.