Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
HELP! substitutes needed
I'm working on a 915MHz mixer design, and just run into a challenge of unavailability of these components
1.Varactor diode BB131 (philips)
2.Feedback amplifier transistor AT-41486 (agilent)
3.Schottky diode BAT15-04W
4.RF transformer JTX-2-10T
pls I need suggestions...
RF simulation
Please I need a simulator for RF/microwave circuits
I am designing a mixer and I need to simulate my work so far because I'm doing it in stages. Please help!
power amplifier tutorial
i've been looking for an ocillator circuit for my project for sometime and this site has just been of help to me.
thanks for sharing
915 MHz MIXER
Pls I have this project to work on and I don't have a circuit diagram to implement it. Pls I need help cos time is running out. I have rather broken it down to its constituent block diagram
1. Local Oscillator to generate the carrier
2. A frequency multiplier in case I cannot get...
Re: 915 Mhz mixer design
No I have not received any specs
Added after 2 minutes:
i think I need to design using diodes or tansistors
i will be very happy to get the circuit design
Thanks a lot
I can use GSM, RF or bluetooth depending on the most feasible. Never heard of Zigbee.
Added after 7 minutes:
Thanks
I've seen the site.but I don't know how readily it's available. I'll try to find out more about it
gsm wireless led display tutorials
Please Help
I'm working on a scrolling LED display using 5X7 dotmatrix. I'm inplementing on PIC18F series and looking for a means of updating without wires. wireless or infrared using RS232 port. Please I need help.
proteus led matrix
Is it possible to design a scrolling LED display without using shift registers?
Added after 5 minutes:
I actually want to solder the led matrix myself...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.