Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
Give me a guidelines about 15inch resistive touch screen wiring connection.
My reference project link
https://www.hackster.io/davidhamor/ball-and-plate-c48027
1 and 3 resistance value is 530 ohms (Y+ , Y-)
2 and 4 resistance value is 300 ohms (X+ , X-)
This pin numbers are correct or not? Touch screen model - ST-151001 (ST-008)
Hi,
Am connecting 4 wire resistive touch panel to arduino uno board. (Am using TouchScreen.h library)
pressure is always zero. I need to know 4 wire resistive touch wire connection.
Thanks for your reply.
Primary wire size - 27swg
Secondary wire size - 42swg
ferrite potcore with bobbin - 18x11
Output voltage - 260v. How to measure Output current? When am connect a ammeter, the values are not shown(zero).
Hi,
Am using MAXIM 1771 step up converter. Existing POT core was heated (30 min running time). Kindly suggest any manufactured based POT core.
POT Core specification for your reference:
Primary Inductance - 3mH
Primary Resistance - 0.4E
Sec Inductance - 170mH
Sec Resistance...
Hi,
I'm doing Electronic ignition coil Testing Setup. How to measure High voltage coil (23kv)
output?
Kindly suggest me, any idea to test Electronic ignition coil(Voltage / Current / RPM).
Thanks
PSK.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.