Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I thought the solution vanished for m=0, n=0 , am seeing a lot of publications related to optical waveguides, mention a tm00. Here's one that am referring to. I need to reproduce this using CST microwave but unable to find a mode that has Ex as shown in fig. 4.
Thanks.
how do I find the fundamental modes? For eg. am trying to simulate a dielectric waveguide in air? I am using a discrete waveguide port at the ends.
Am not sure about the boundary conditions in CST? Can somebody explain open boundary with add space?
Thanks in advance
I am starting off with a simple case of lossless dielectric filled waveguide with lossy dielectric segments on it's sides. I did a parameter sweep varying loss and looking at Ez. I am interested in TM11 mode and hence would like Ez to be high. I am using the transient solver to run this.
I put...
I have a question about the mill bits for quick circuit 5000. I need to order smaller endmills for milling RF boards. T-tech has been slow in responding to my order. I am wondering if there are any reliable vendors anyone here can recommend. I looked at **broken link removed**.
Looking forward...
Hi,
I am new to CST as well as PCB milling. I tried exporting a antenna simulation from CST as a gerber file. ISOPRO does not register the aperture list for some reason. All it shows is D999 with 0 width.
I also tried to view the gerber file using McCAD. Again McCAD shows an empty aperture...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.