Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi,
after you deleted a pin from the schematic, you should recreate the symbol. Symbols will not be automatically updated when you change the schematic of it.
Hope that is helpful to you.
fern
Hi,
I have some questions regarding Assura LVS/RCX.
1) How to debug Assura LVS? To debug DIVA extraction, I used to use saveDerived and view the layer in the extracted view. But Assura there is no extracted view, so how to go about debugging?
2) Can I run LVS after RCX? This is to check...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.