Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
It is called multi part component in Altium. You need to create the component in proper way in library, where each symbol is drawn as Part under one Component. Look at New Part command in schematic symbol editor. Then you need to have same Designator to all parts to get them all to one...
It is available in Altium. You need to set Mask expansion to 0mm or more to open solder mask automatically (select entire connection by S,C shortcut and then set the mask value in Inspector panel or do that via rules). When the board will be soldered by paste you can open the track in solder...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.