Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
If i power on motherboard its starts normally but when start again after shutdown it don't show display at all, i have checked for pci reset , and FWH reset signal's its also shows low that time. please help to solve this.
do you have pci debug card for test ?? if you have one then check reset, clock signal for normal on it then check for normal heating of processor chip then check core voltage is good , then check for power good signal route from vrm chip also check if some code is generated on pci debug card...
hello have solved your problem ?? if not then try this one check with keyboard and touch-pad connector removed if it pass post then your keyboard is faulty.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
