Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear all,
I have a layout and the corresponding extracted view in cadence 5.1. Now I want to use Analog Design Environment to do simulations. Is this possible? For example creating a symbol which is binded to the extrated view and its Ports would be perfect.
Best Regards,
Peter
Hi Erikl,
thanks for your answer. In principle you understood my question right. What I'm trying to do, is to "create" a symbol out of the netlist of my extracted view, so that I can use this symbol with all the pins in a schematic for the ADE. I just don't know how to do this.
Bet Regards, Peter
Dear all,
i have the following problem. I desigend an IQ-mixer with two mixers and one polyphase filter at the input in cadence. I therefore made one schematic and the corresponding symbol for the mixer and a spereate schematic and symbol for the filter. Same with layout and extracted view...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.