Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have the same problems with the R131 to R133. I think they are 0.200ohms from the markings but you might put in a single higher wattage leaded 0.47ohm resistor to replace all four surface mount units. Later, you can put another in perallel to up the power output. The transistor is a 600V 6A...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.