Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The point of this circuit is that many times you have a limited selection of supply voltages in your board, maybe +12, +5, +3.3.
So, what do you do if you need to give 8V to some load/circuit?, this is where a circuit like this fits.
Of course, the ideal solution is always to have a supply...
Re: What program supports 2D sheet metal and fold lines ->
You can design sheet metal parts with SolidWorks, although very expensive. A more affordable option is Alibre design, also has sheet metal parts design.
In both software, the usual workflow is to design the part in 3D, and the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.