Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Ok, so as you may or may not know, I am working on a printer. I am building it myself and have been taking more printers apart than you would believe.
I'm at the point where I need to either find a source and probably buy in bulk for standard LPI digital encoders used or use an Arduino 360...
Been testing out batteries now for the last couple of weeks now. I have two bridged 18volt drill batteries and I'm getting about 2.5 hours use out of them. Not to shabby but I was really hoping to be able to get to that magical 3 hour mark. Wondering if I make the unit self charging I may be...
Hi all, I'm a newb on this and am trying to figure out some math. I seem to be running into a wall. I'm converting a small module to run on batteries and am trying to figure out what size rechargeable batteries I need for 3 hours of run time. Operational power consumption is 13watts
Any help...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
