Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
can anybody tell how to Calculate Transmission line feed Length,width and gap for a rectangular patch.i am unable find the exact formula.
my patch width w=49.6 mm
patch length l=39.55 mm
freq=2.4 ghz
substrate height h =1.6mm
relative permitivity = 2.2
thanking you.witing for solution.
What will be extension for touchstone file to import in N-port in Ansoft Designe
i have saved the data in notepad.
But my designer cannot identify the touchstone file. What's going on.
where from i will get the default values.because whatever JFET i will use to design the circuit that JFET parameters are empty.i have tried almost all .the main problem is that every case parameters are empty.
Hey
i am designing an distributed amplifier using FET in ADS.But in ADS whatever FETs are available that dont have values of parameters. where from i will gwet the FET parameters. kindly give me suggestions.
haii all,
i am designing an distributed amplifier using FET in ADS.But in ADS whatever FETs are available that dont have values of parameters. where from i will get the FET parameters. kindly give me suggestions.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.