Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi,
i have made a patch antenna in hfss.the problem is while exporting it to dxf , i only get the bottom face. can you help me in this regard?
its urgenttttttt!!!!
help meee :(
thanks in advancee :)
attached is the hfss original file.
hi,
i am new in the field. can anyone help me in exporting the hfss file as dxf. i have set all z=0 bt still the dxf file has only bottom layer.
my antenna is a simple patch antenna with partial ground
thanx in advance
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.