Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello...
I have developed a custom ESP32-C3 board for my home lock. I am using a lithium battery 18650 with 2200mAH. I am poor in coding and started to code from past 2 months.
Well, I need to connected with the WiFi always, as if I press unlock on the blynk app, the motor should rotate to...
Hello,
I am working on a project where I need to send I2C or, Analog Data between two PCBs (main PCB and Sensor PCB) using the TX and RX pins of the USBC conntector. The main PCB has a battery charger which will take input voltage from the same USBC connector. I am not willing to use additional...
Obviuosly, Without getting information about the PCB it is quite difficult for everyone.
PCB is new. Soldered and tested. No resudal of solder flux, properly cleaned.
1624868127
Such a great trick, never thought before. Worth a try.
In INDIA there are lots of SMPS available with two plug pins. Unfortunately, while earhing is a standard safety practice, It is hardly available in every here and there places in INDIA.
I have checked JioFiber Router (A Router for 4G internet in INDIA) that uses 12V 2A three pin wall socket...
Wow... Lots of advices. Please give me time to reply one by one. Sorry I was inactive yesterday.
1624866010
Hi... I have not used the 0.15nF, I have ordered few and let all of you know.
I have used 1nF 2kV Y cap, generic one, no partnumber since it is locally available. I have 1nF and 2.2nF...
Yeah, but I hope it is done for EMI supression related issue. Is there any better option without removing this one? Or changng the EMI circuit that produce same effect without the C4?
Thanks a lot.
Greetings to all.
Lets discuss about my problem -
I am making a power supply to power Audio instrument having 12V 1.25A rating across the output.
Here is my circuit -
Now when I connect the AC it is working as expected but the problem is I am feeling AC shock of low voltage across the...
Umm not 10 minutes but it is taking almost 1-2 minutes. I dont know why it is not that long you assuemed. Maybe because of the Capacitor ESR value or the real scenario. Surely I will divide this into two stages.
Nice help. Thanks a lot.
Thanks a lot KlauST.
Such a informative post. I have used a series resitor in the input (0.1 Ohm). The Resistor drop voltage further forwarded to a Low Pass filter that is charged to the mean value. I have taken this voltage and as per ohms law as average current and calculated the power...
Hello,
Greeting to all.
I am having difficulties to measure PWM based motor control circuit power measurement.
Let me explain further. I have a motor that can be controlled by varying DC voltage across the motor or using PWM based signal. I want to make a comparision between How much power in...
Hi....
Thanks FvM and all of you. Finally I made it. I have removed the MOC3031S and connected the mcu negative via a 100k resistor to the neutral line. The COM pin of the ACST is now connected to neutral as well as with the MCU with a series resistor. The load is connected in series with the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
