Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
dipole in water
Hello jallem, I'm embarrassed but I need to address you, that have been very kind, a last answer (I promise this is the last :!: ).
My intention was not that of making an electrically small dipole, i.e. a dipole long between lambda/50 and lambda/10, but a half wavelength...
small dipole for 433mhz
Hi jallem, thank you very much for helping me.
In my original projects the frequency sweep was between 200 MHz and 800 MHz. I have been using PML because radiation didn't give me good response,so I thought it was a matter with boundaries.
I followed your suggestions and...
433mhz диполь
Hi jallem!
Thank you very much for the reply.I embedded the dipole in polyester before immersing it in water with positive conductivity.I'm posting three project because I don't know what is the best, since I'm trying to put PMLs in the best way, without knowing well how to...
dielectric constant of water frequency
Hello everybody!
I'm a beginner in the use of HFSS and I need to simulate in open space some coils, so I began to run simulations with dipole, but in water the s-parameter obtained rescaling the length of the antenna to resonate at my desired frequency...
Re: Assign material properties to each tetrahedron of the me
Hi Azulikit, hi Athrean,
I'm interested in a human body model in HFSS 'cause I'm doing a thesis about hyperthermia. Did you find this model by ANSOFT? Is it possible to get it for free?I would be very grateful of a reply.
Bye Pamela 81
Re: loop antenna
Hello kangkang, I'm doing a thesis about hyperthermia and I need the examples on loop antennas, because the subject of my thesis is just that! Could you help me and send me those examples, please? My e-mail box is at corallara2000@yahoo.it
Bye Bye, thank you very much!
Could somoeone tell me how to displace a wave port when doing a parametric calculation that enlarge the structure translating the source?
Thank you very much
hfss spiral
You can find under 'draw' a user defined primitive that is a square coil.I put a ground (GND) plane under the coil, assigning it the property of PEC to it and then connected the GND to the coil by a cylinder of some conducting material. I draw a rectangle between the other extremity...
I need the same thing: drawing two half spaces facing each other...the only infinite thing I found was the ground plane, but separating an half space from the other by it means imposing a screen that prevent backscattering of waves.
Another thing Inoted was that the simulator divide the space...
Hello Sayyan79
I would use a subordinate coordiate's system which has a center located along the axis on which you want to split the cylinder and after this I would rotate the solid around the plane that you just translated; for example if you want to locate the cylinders along the y-axis move...
If you want to apply wave ports to the interior of a structure, you must create an inner void or select the surface of an interior object that is assign a perfect conductor material property. Inner voids are automatically assigned the boundary outer.You can create an inner void by sorrounding...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
