Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by paley

  1. paley

    How to used this Li-Ion Battery Equivalent small signal Model

    hi, guys in the application document of TI's BQ2472X/3X which called "Closed-Loop Compensation Design of a Synchronous Switching Charger Using bq2472x/3x", there is a Li-Ion Battery Equivalent Circuit Model, How to used this model? the description as blow: "Figure 15 shows the typical Li-ion...
  2. paley

    Looking for a Vbe/R bias generator

    Hi, Guys I need a Vbe/R bias generator, and the Vdd can be low to 'Vbe+Vth', pls help me, thanks
  3. paley

    Who is your idole in Analog Design?

    G.C.Temes. and Willy.Sansen,
  4. paley

    problem on LDO ac simulation.

    agree with rajanarender_suram
  5. paley

    What is the best layout editor?

    virtuoso is better than the others
  6. paley

    some question about sar adc

    1.it is essential to cancel the offset of camparator in a SAR-ADC 2.it's not need calibration in a 10bit sar adc
  7. paley

    Example of rail-to-rail output amplifier

    op-amp question you can refer to a paper about class-ab amplifer in JSSC94, i'm sorry that i forget the paper name
  8. paley

    Phase Compensating Capacitor

    what is phase compensating refer to Razavi's book
  9. paley

    I need soma papers about CML pfd

    I need soma papers about CML pfd, Could you help me? Thanks
  10. paley

    What is the best OS (Operating System) to you

    OF COURSE LINUX IS THE BEST
  11. paley

    looking for advice of learning DC-DC

    Fundamentals of Power Electronics by Erickson is very good
  12. paley

    How to measure the characteristics of an Op-Amp ?

    Measuring an Op-Amp you can use a same mos connect to the another side of res
  13. paley

    how to generate reference voltage

    you can use a buffer and then a resistor divider
  14. paley

    how to simulation the performance of a auto-zero circuit?

    if i used hspice, how to simulation? thanks
  15. paley

    how to simulation the performance of a auto-zero circuit?

    Re: how to simulation the performance of a auto-zero circuit Hspice and Spectre
See more

Part and Inventory Search

Back
Top