Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
dvb-t signal meter
Good evening,
the price of a DVB-T meter (to analyze digital terrestrial signals) is too high for my pocket :D so I was looking for a complete circuit (a kit) to build it myself. I did not find anything.
What I need is an istrument to measure the level, the BER.......all...
Re: DVB-T Ber meter
Hi mate,
thanks for your reply. I do not need a simulation. I need to build a cicuit to measure the DVB-T Ber.
Thanks anyway for your help
You are 100% right. The suggestion of to use a PIC was of course related to control section of this circuit. I found this usefull link:
**broken link removed**
In figure 13 you can see the basic blocks of a level meter. Do you know some dedicated schematic or IC to implement the IF...
Good evening,
I'd like to design a circuit to measure the terrestrial TV signal level (measured in dbµV) on a display. As you well know, this is a function available on a TV Field Strength Meter.
This circuit must allow you to select the TV channel (frequency) so you can then measure the...
Changing signals level
I am making some modifications on a smartcards reader. As you know a generic smartcard uses some signals like : Vcc (Power Supply), Rst (Reset), Clk (Clock), I/O (Input-Output), Gnd (Ground).
At the moment I can modify the level of this signal and this means , for...
Thanks all for your posts.
Regards.........
Overflow91
/ Warning #1 - No thanks at Elektroda! Read forum rules before posting! www.elektroda.pl/eboard/viewtopic.php?t=40389 /
Hi,
thanks for your reply. I want to give you more information. I am designing a reader/writer for smartcard. Now I have to put a capacitor between the VCC and GND pin of the smartcard. Now the question is : what kind of capacitor to use ? Multilayers or poliester ? And for what reason I need...
Hi all,
I am designing a digital circuit and I need to put some capacitors between the power supply VCC and the ground GND.
Could someone explain me the difference on using a multilayers capacitor instead of a polyesther one ?
Thanks a lot...........
Hi all,
please can someone tell me where to find a good project (schematics and software) to build an IDE to USB interface to external connect my hard disk ?
Thanks in advance.......
Overflow91
Macrovision
Hi all,
I already searched on this forum for a "Macrovision Remover" schematic but I did not find much usefull information.
Please could someone point me to a link where I can find the schematic to realize this interface ?
On this forum I found a link but it points to an adult...
interface nokia 7650
Hi all,
I need the schematics to build an interface to connect (via infrared) my GSM telephone NOKIA 7650 with my personal computer. Please can someone help me to find ?
Thanks in advance,
Overflow91
visual c++ usb
Hi all,
I am searching for a library (a .lib file) to develop an application with USB support. Please can someone help me to find this library and the specifications to use it ?
Thanks a lot
Overflow91
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.