Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by osmanpasali

  1. O

    why fpga is used in obd diagnostic devices of automotive

    Most of the obd diagnostic devices have fpga or cpld.what is the purpose? Why cannot mcus be enough?
  2. O

    Could not find out expressions on Renesas R8C/1B ic

    Hi everybody, I bought Renesas R8C/1B mcus. It is written "1B4 J3C0" on the mcus. on the ones i bought before it was written "1B4 F4K0". what do these expressions mean?
  3. O

    How can i enable code protect using E8a debuger/programmer?

    hi everybody, I am using r8c/1b controller and e8a programmer. i want to protect the software. how can i do it?
  4. O

    Renesas R8C A/D converter question?

    thank you for your answer.. i will try it. by the way how can i use internal reference?
  5. O

    Renesas R8C A/D converter question?

    Hi, Although i connot get answers to my questions i continue asking...... Can i connect VCC pin of R8C/1B to 3.6V and Vref pin to 5V? I mean Can Vref of A/D converter be connected to a source greater than Vcc of the MCU?
  6. O

    how to drive the MOSFET

    block diagram ups there are special ic's for driving mosfets....
  7. O

    RWS-375 current consumption

    rws-375 hi everbody, how much current do RWS-375 series receivers consume? it is not given in the datasheet....
  8. O

    rf receiver module and debugger problem....

    hi everybody, today i saw an odd situation. i have a circuit on which there is a receiver module with a digital output and the output is directly connected to an input pin of an mcu. i observed the digital data output of the receiver and saw normal parasitic data. but when i connect to the mcu...
  9. O

    can i receive rf data with a mcu?

    yes it outputs digital data. what is important when sending digital data? timing or high-low transitions?
  10. O

    can i receive rf data with a mcu?

    I mean there is an RF receiver which outputs serial data, connected to the mcu. can i resolve the data via software?
  11. O

    can i receive rf data with a mcu?

    hi, i want to receive rf data coming from a uhf receiver without a receiver ic. i want to use an mcu instead. is it possible
  12. O

    How can i program 12f series with ICD2?

    is there a shematic of that adapter? Can i build it?
  13. O

    How can i program 12f series with ICD2?

    Hi, How can i program 12f series pic mcus with an ICD2 and PICDEM2 plus demo board?

Part and Inventory Search

Top