Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
With regard to xbees, they work with 3.3V and thus have a output high voltage of 3.3V. And I am directly connecting that 3.3V output to the PIC's serial input.
Do you think there can be a problem, with PIC not being able to interpret 3.3V as high?
Actually I used X-CTU to configure the xbees(in AT mode) and afterwards I tested them from two computer terminals.
I am not using hardware control lines for flow control implementation because there is no such a need in this project. I am going to send 4 bytes of information every 3 or 4...
Hi everyone
As it is apparent from the title, I have a communication problem between PC and the PIC. Xbees are definitely configured correctly because I tested them by connecting between two computers and sending data from one to another.
What I am basically trying to do is send a character...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
