Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Easy peasy,
All I know is what was included in the problem statement (attached). All else I cannot provide because I do not have enough experience in whatever you are talking about. I know that the waveforms provided as a solution look like the ones attached. My question is how can we model the...
Easy peasy,
Well, if I knew the software I wouldn't post questions here. So, please provide constructive guidance and/or suggestions, otherwise don't post anything. Tell me exactly what I need to change about the circuit. :-)
Also, I would like to add that the 10Vdc is the back-emf of the motor.
Greetings Pspice Experts,
I am attaching the results of simulation. The results do not look anything like that of the book. The way I set the Vpulse model is by double-clicking on each of the properties and setting the value. Please confirm if this is correct. What values should I be setting...
Easy peasy,
Please provide the definition of sw frequency, what does it mean, and its purpose. Also, what is the source of ripple current? I know that when converting AC to DC there is a small ac component which is desired to be small and that is why a smoothing capacitor is used for such...
Greetings. I have replaced the SCR with an NMOS. The 1mH inductor is part of the 'motor' armature which is represented by resistor, inductor, and back-emf (10Vdc) combined. Correct me if I'm wrong, but the back emf is only applicable during steady-state operation of a motor, such that it has...
Greetings Experts! I am trying to solve a homework problem on the subject of Power Electronics (DC-DC Converters--Buck Converter). The following problem statement has been provided:
1. Ideal source battery = 100Vdc
2. Load = Series combination of resistor (0.25 ohm), inductor (1mH), battery...
Good Day Experts,
I have several questions in regards to a Power Electronics lecture from nptel. I would very appreciate your help if you could explain/answer my questions below shown in the image.
Link to lecture 11: https://youtu.be/uDD_USRCtOE
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
