Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
the code is working in the real harware , and the value is shown in the display . just i dont get it why the value doesnt display at proteus
adc16f887
#define _XTAL_FREQ 20000000
int read_adc(unsigned char channel);
int read_adc(unsigned char channel)
{
ADCON0=0b00000001; //Turn on A/D...
Re: Error msg in Proteus
I already put the LM35.IDX, LM35.LIB to LIBRARY folder and lm35.mdf to model folder. I also have simulate it using both .cof and.hex file. when I try it at hardware, it can display the value,
adc code :
#define _XTAL_FREQ 20000000
int read_adc(unsigned char...
Re: Error msg in Proteus
My LM35 already didnt display that error when play , but the prob is the LCD doesnt display the analog reading. and when i stop the simulation the error come out again .
Re: Error msg in Proteus
Thanks for the reply .
but I still don't get it how to check wheather the model is inside the library or not.
thank you in advance.
Hello, I'm new here and need help. In the simulator Proteus to simulate the LM35 temperature sensor gave the following message and I had never seen before and do not know how to solve, if anyone has a hint will be welcome, ok.
"Can not find model 'LM35.MDF.'
Pin ' VS + 'is not modeled.
Pin...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.