Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello!
I'm doing a school project and i am suppose to draw the schematics of this MTS310 sensor board on Altium Designer. But i'm not sure what is the 2conpads and 4conpads? (Refer to picture) Please help.
And also, how do you create mounting holes on the pcb?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
