Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Please refer AMBA AXI v.1
Chapter 10 on unaligned transfers
In Figure 10-1
The start address is given as 0x01 and transfer size is 32 bit. If the data were to be 0xDDCCBBAA, then what is 0x01 corresponding to. Is it byte AA or BB. If it is AA then DD goes to address 0x4 which...
specman basics
if anybody have specman basic training lab material,(specman sbt_lab material)
these lab sessions are provided in a standard specman basic training.....
kindly upload or sent to me.
thankyou ......
beat burst axi
HI
kindly help me out......
In AHB/AXI protocols if the size of transfers is less than the bus width (narrow transfers), for example , if it is 1byte transfer on a 32 bit bus and offset address is 1 , transfer is on second byte lane (AHB). (Little Endian)
similarly for 32...
HI,
can anyone explain how to calculate the cell address in BVCI packet using BE. (refer vsia-vci BVCI protocol)
Also do all Byte Enable(BE) rules of PVCI apply to BVCI?
thanks & Regards
novice
Re: AMBA question
hi uditkumar!
thanks for ur kind reply.
so is it that address lines HADDR[31:10] are used to select slaves and HADDR[9:0]
are used to address internal registers of the selected slave?
thanks & regards
novice
am new to AMBA, and this would be a very simple question to u all,
what actually is the rold of HADDR[31:0]? and
it given on page 3-5(AMBA spec) that ,
"incrementing bursts, which do not wrap at address boundaries,
wrapping bursts,which wrap at particular address boundaries"
thanks
novice
solution manual randy h. katz
Hi everybody,
can anyone please provide me the solution manual of
1) contemporary logic design -Randy h. katz
2) fundamentals of logic design- Charles Roth
also advanced degital design problems with specs, which require FSMs(with solutions if possible)
any...
c-dac pune,is good but they prefer mostly B.tech freshers not even m.techs
TIIT, hyderabad is also a good one, give lot of asignments, have idustry std tools,
vedaiit is also a good, but entrance is very tough!!!
-novice
vlsi and nanotechnology
does nanotechnology pose dager to vlsi enginers jobs in particularl to physical design engineers?
may be am unable to put the question right, but hope u got my point!
( i don't mean nanotechnology by 90nano or 45nano....)
-novice
solution manual rabey
can any one upload solution manual to
DIGITAL INTEGRATED ELECTRONICS -A DESIGN PERSPECTIVE by JAN RABEY,
be it First edition or Second edition.
its really a great book for eveyone intetrested in vlsi
thanks in advance
novice
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.