Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
gultepee, thank you.
In my model,
a lumped port for an antenna, and set scaling factor as 0 in "Edit Sources";
an incident plane wave, scaling factor 1;
how to see the simulation result, how can I get the response on the lumped port?
In results-> creat data report , I find only those like...
help in C syntax
1)
<< is Bitwise left shift,
>> is Bitwise right shift,
so it looks like multiplication by power of two.
2)
with those good books, you can find the information between arrays and pointers.
for example,
this two expressions:
a[f]
*(a+f)
are equal in some case.
3)
in your...
As TheArcane and tallface65 said, you should defined the feed of the patch antenna.
I think, what you are modeling now is sth like FSS - frequency selective surface (act as a filter) ; apply two Floquet port, one on top, one at bottom, and apply Master/Slave Boundary at walls of the cell...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
