Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Laser Soldering: minimum hole applicable and depth? :arrow:
Hi guys,
I need to ensure that the press fit pins are very stable by applying solder to it and the best method I can think of is laser soldering after SMT + Press-fitting the connector. Unfortunately the hole diameter is 0.3mm and...
Thanks thylacine1975 for the useful info! yes i have already accounted the losses on both input and output interconnects. Freq is C-band and other units @ 80W. regards :)
Hi forumers, I have an upconverter module rated 60W with gain of ~40dBm. I am currently connecting the 30dB 150W attenuator directly to the output port (N-type). I am planning to put the attenuator inside a testbox, so I will be using a test cable to connect the DUT. Is it safe to do so? Thanks...
Thanks for your inputs guys. Not much concern on the loss, but on frequecy; so if I use a low freq cable, say less than 5 GHz from SNA RF out to bridge's RF in, is not an issue if my DUT is in 30GHz+ range?
My measurement is in Ka band. Should I use a Ka band cable from SNA RF out to RF in of the directional bridge? I know its a bit expensive but is it a requirement?
Thanks in advance. :wink:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
