Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi..
I have done my interfacing of 24C512 with 89c55, Reading writing everything working fine..
But the problem is i tried to write alphabet on a particular location; say 0x00A0... writing done successfully; and when i tried to read it back instead of 0x00A0, same data is available at...
PAGE-1 and 2 shows the receiver Section.
in this section i used IN, OUT and Balance(IN-OUT) in seperate displays. each of them uses 3 digits. ie it will count from 000 to 999. and reset to zero.
hi...
have anyone done interfacing digital potentiometer(AD5162) with 89c52..?
if so help me with programing..
i am not familiar with the SPI programing..
AD5162 datasheet attached below
Does anybody have any idea about universal programmer, that can retrieve program from 89c52 micro controller..!!!!! and its cost too... Then email me on nitheeshthavakkara@gmail.com... plzzz.....
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.